العودة إلى المدونة
أدلة إرشادية 2026-11-17 Pro Shrimp 1 مشاهدة

Dennerle Plant Care P and K: Dosing Phosphate and Potassium

Dennerle Plant Care P and K: Dosing Phosphate and Potassium

How to use Dennerle Plant Care P and K in a planted shrimp tank: what each bottle adds, how the 2ml per 100L dose works out, and when phosphate or potassium is the one you need.

Two single-nutrient bottles, two different jobs

Dennerle Plant Care P and Plant Care K are separate fertilisers, not a paired set you must always use together. P supplies phosphate; K supplies potassium. Both are described by Dennerle as being for demanding planted aquaria and as very useful in no- or low-fish-stock tanks with dense planting, including planted shrimp tanks.

That makes them tools for a specific gap rather than an all-in-one feed. The practical question is which nutrient your setup is short of, and the answer comes from your plants and your test results, not from adding both on a fixed schedule.

What the two bottles actually deliver

  • Dennerle Plant Care P - Phosphate: Dennerle Plant Care P is a phosphate fertiliser for demanding planted aquaria; 2ml per 100L adds 0.2mg/L phosphate, and the bottle is 250ml. The dose is small and precise, so you can add a trace level of phosphate without turning it into an algae-feeding overshoot.
    Dennerle Plant Care P - Phosphate
    Dennerle Plant Care P - Phosphate
  • Dennerle Plant Care K - Potassium: Dennerle Plant Care K is a potassium fertiliser for demanding planted aquaria; 2ml per 100L adds 1mg/L potassium, and the bottle is 250ml. Potassium maintains plant health and improves colouration, especially in densely planted setups, and the 2ml dose makes it easy to add a measured amount.
    Dennerle Plant Care K - Potassium
    Dennerle Plant Care K - Potassium

Why phosphate deserves a careful hand

Phosphate has a reputation for encouraging algae, and Dennerle's own product information acknowledges that too much of it can be a problem. The same information is clear that a trace level is still required for plants. Plant Care P is built around that balance: a small, measured addition rather than a blanket feed.

This is why the bottle suits low-fish-stock, heavily planted tanks and planted shrimp tanks in particular. In those setups the plants are the main consumers, and a trace of phosphate supports them without the heavier phosphate load that fish waste can bring in a stocked community tank.

A measured dosing routine you can repeat

The supplied records give dose rates but no manufacturer step-by-step schedule, so treat the sequence below as a practical way to apply the stated rates, not as a Dennerle instruction.

  1. Work out your tank volume in litres: Both dose rates are quoted per 100L, so you need your actual water volume before you can measure anything.
  2. Decide which nutrient you are targeting: Use Plant Care P if you are addressing phosphate and Plant Care K if you are addressing potassium. They are separate products with separate rates.
  3. Calculate the dose from the stated rate: For Plant Care P, 2ml per 100L adds 0.2mg/L phosphate. For Plant Care K, 2ml per 100L adds 1mg/L potassium. Scale the 2ml figure to your volume.
  4. Measure with a syringe or dosing pump: The volumes involved are small, so a graduated syringe gives you far more control than pouring from the bottle.
  5. Observe the plants before repeating: The records do not specify a dosing frequency, so watch plant response and your own test results rather than assuming a fixed daily or weekly schedule.

Plant Care P or Plant Care K: which one fits your tank?

  • Choose Plant Care P when: You run a demanding planted tank with no or low fish stock, dense planting, or a planted shrimp tank, and you want to add a trace level of phosphate without overdoing it.
  • Choose Plant Care K when: You want to support plant health and colouration in a densely planted setup, again with no or low fish stock, including planted shrimp tanks.
  • Consider both when: Your setup matches both descriptions and you have a reason to address each nutrient separately. Because they are single-nutrient products, you can dose each on its own terms rather than being locked into one ratio.

Shrimp tanks and the low-stock advantage

Dennerle specifically notes both products as very useful in no- or low-fish-stock setups with dense planting and in planted shrimp tanks. That is a useful signal for shrimp keepers: the products are aimed at planted systems where the plants, not a heavy fish load, are doing the nutrient work.

What the supplied information does not do is give shrimp-specific dosage adjustments or a compatibility statement beyond that planted-tank context. If you keep shrimp, dose conservatively, change one thing at a time, and let the tank tell you whether the addition is helping.

What the records leave open

The supplied information gives clear dose rates and bottle sizes but no preparation steps, no dosing frequency, and no instruction on mixing the two products. It also does not state a target phosphate or potassium level to aim for. Those gaps are a reason to test and observe rather than to guess a schedule.

What you can rely on is the arithmetic: 2ml per 100L adds 0.2mg/L phosphate with Plant Care P, and 2ml per 100L adds 1mg/L potassium with Plant Care K. Build your routine around those figures and your own tank's response.

مقالات ذات صلة

Customer Service
الرئيسية
المنتجات
السلة
الملف الشخصي